RHEEM
RHEEM SP20716 -Ruud IGNITOR
IGNITORIgnitor overviewRheem's IGNITOR gas valve is an automatic stay-open gas valve that allows continuous pilot operation. The IGNITOR has a 900 degree F open flame, and is efficient for both low...
My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New AccountIgnitor Wire
The Ignitor Wire is a replacement part that can be used for the RHEM 7250P-653. This product is made out of polyolefin and meets all of the applicable industry standards.
RHEEM Ignitor Wire for models up to 16 SEER (7250P) and 17 SEER (7350P/7450P), 6500 Series, and 6100 Series. This is a 4 feet long wire that goes from the control board to the ignitor on the coil.
Ignitor wire for Rheem/Ruud water heater models 7250P and 7300P
RHEEM Ignitor Wire is used to replace a worn or damaged wire on the gas valve.
RHEEM Ignitor Wire is an ignition wire used to make various repairs to RHEEM residential gas water heaters. The RHEEM Ignitor Wire has a built-in resistance of 15 Ohms. The RHEEM Ignitor Wire is flexible which makes the wire easy to use, while also coming with electrical connectors.
RHEEM Ignitor wires are designed to jump-start ignition on gas furnaces. If you hear a clicking noise in your furnace, an Ignitor wire may be needed for repair.
If an ignitor wire is broken, discontinue its use immediately. This replacement ignitor wire can be used on gas/propane models and part numbers listed below