YORK S1-02427688001 SWITCH,PRES,LOW, .6 IWC ON FALL,SPNO

SWITCH,PRES,LOW, .6 IWC ON FALL,SPNO

The SWITCH, PRES, LOW, (SPNO) is a Class 10A non-logic SPNO and an overcurrent protection device used for the lighting circuit and general electric loads. It provides limited interruption of current in low voltage generators with the values from 1 up to 32 A. It may be installed on 110 VACN of 50 Hz frequency systems in protected locations.

The S1 Low-Voltage Photoelectric Switch, 0.6 Inch On Fall, Standard ON-OFF is used to automatically switch on a light circuit when the light reaches .6 inch from the bottom of the photoelectric tube.

The SPNO switch controls the High Limit Stacking Press and prevents it from operating without a full tub. The low limit switch is connected to the LVN Heating Pellet Monitor and allows the heater to circulate air past the pellets automatically if the temperature in the pellet chamber drops below 137F. The IG/OV (Ignition/Overheat) switch raises, lowers and de-energizes the cylinder gas piston valve to start and stop ignition of a charging cycle.

The S1 "On" indicator switch has no spade terminals. It is used to sense a low voltage condition with a change in a low pressure (less than .6 PSI). The "ON' position of the switch connects the load to a circuit and the 'OFF' position disconnects it.

Medium Miniature SPDT Toggle Switch, SPST ON-OFF-(ON) 24VAC or 28VDC Contact Rating: .6A @ 12VDC Overall Case Size: .097 x .505" (2.5 x 12.8mm) Terminals: Solder 10-32R Insulation Resistance: 1013 ohm Minimum Current Ratings: SPDT - 0.6A @12VDC On - 0.6A @12VDC Off - 0.6A @12VDC #SW07

Also known as the contact, the low-voltage switch cuts off power to a low-voltage circuit when it is unobstructed. This Eaton device has been designed for use in commercial, industrial or utility applications. It will operate on low voltage circuits and 600V ac circuits with 1800/120V/60Hz, 20A. Standard SPST (2NC, 3NO).

The YS Switch is a low pressure switch for air conditioning and refrigeration systems. It has been factory sealed with high temperature silicone sealant, and must be used in a liquid cooling or heating system.