Globe
THERMAL CUTOUT for Globe - Part# U00577
THERMAL CUTOUT for Globe - Part# U00577THERMAL CUTOUT for Globe - Part# U00577The Globe U00577 thermal cutout is designed to prevent overheating, motor burn-out and premature failure. This thermal...
My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New AccountTHERMAL CUTOUT for Globe - Part# U00577
THERMAL CUTOUT for Globe - Part# U00577
The Globe U00577 thermal cutout is designed to prevent overheating, motor burn-out and premature failure. This thermal cutoff switch regulated at 185°F (85°C) detects when the pump has overheated due to a bad impeller or power supply overload, and then safely shuts off power to the unit.
The Globe - Part# U00577 is a replacement thermostat, this part should be used as a replacement for the old CIRCUIT BOARD if you are having trouble turning the heater on and off. This part should not be used on models other than Globe
The Thermal Cutouts are designed for use with our Globe (U00528) and Eclipse (U00427) Heaters. Features include four inch cutout, two inch threaded fitting and large filter area to ensure long lasting performance.
Thermal Cutout for Globe CV-552 and CV-590 Series Wall Heater.
Use this Thermal Cutout to safely isolate your Globe from a neutral ground. This will prevent potential over voltage hazards and protect your valuable equipment. This device should be installed by a qualified electrician.
NEW Globe by A Metal USA adds the Thermal Cutout for safety, allowing the globe to disconnect from the power pack if any heating issues occur during a session. This upgrade is available for new or retrofit installations.