Veris Industries EP2100S Electropneumatic Transducer Analog Input

EP Transducer

The EP Transducer from Veris offers precise, repeatable motion control in a small package. When paired with a compatible valve controller (such as the SI3), the EP2100S electrically connects to the valve and converts human input into proportional pneumatic output.

The EP Transducer with 3-pin analog output has a large, solid base to resist shocks and vibrations and keep the sample holder rigid. Its convenience-of-use features include durability in high humidity and dust environments, a long life lens with zero maintenance over its lifespan, a sensor plate that can be cleaned by ultrasonic or wet cleaning, as well as IP67 sealing protection that allows the sensor to withstand total immersion in water.

The EP2100S Electropneumatic Transducer Analog Input (#EP8100) is a transducer designed to sense voltage changes in the range of 0-30VDC. The output pressure range is adjusted by changing the set point on the digital processor and can be varied from 0 to 30 psi (0 to 2.1 bar). The transducer can be wired directly into most industrial control gear, higher outputs are available upon request.

EP2100S is an Electropneumatic Transducer providing a wide range of input from ±10V to ±1000V. The choice between 2-wire and 4-wire signaling schemes may be made with a DIP switch block.

The EP2100S Electropneumatic Transducer lines in, with its broad input range and excellent linearity, is ideal for use as a pressure transducer with air systems. The system also offers an A-B amplifier that makes it easy to connect the line in using a 2-wire system.

The EP-2100S provides an inlet pressure that is referenced back to a vacuum source and is suitable for use where positive, negative or differential pressures are produced by other transducers.

Veris Industries EP2100S Electropneumatic Transducer Analog Input with U-style inlet is seismometer transducers. They measure acceleration and velocity on seismic lines and can be installed inside the bore or hung outside the borehole. The transducers are safe for use with hydrogen sulfide, have a low noise sensor-to-receiver ratio and offer high output to pressure ratio.