York 025-40273-004 LEAVING WATER TEMP SENSOR

LEAVING WATER TEMP SENSOR

Rheem's LEAVING WATER TEMP SENSOR turns the water heat off when staying warm is crucial. The sensor is compatible with select 2-pipe and 3-pipe hydronic systems that use water pumps and hot water tanks, including Rheem AC and Rheem XL AC systems.  It also works with Heatmaster and Prestige hydronic system in return and supply lines for proper installation in the line.

Prevent potential damage to your home by using the York 025-40273-004 leaving water temp sensor with your emergency systems. This emergency valve t-stat is simple to install, with just two wires to connect, and will not activate unless it senses warm water at or above 100 degrees Fahrenheit, which protects indoor plumbing.

The Leak-Free Water Temperature Sensor eliminates the need for repeated water testing. Install it in line or between PEX tubing and leave it there forever. No need to test, clean, replace, or remove. Simply install the flex sensor end by end, right after the cold water facet and before valve(s) on existing water service loop. When the hot water is turned on, this sensor will measure the temperature of the tap water at that instant, which can be viewed on an electrical switch on the kitchen faucet. Converting approximately 1/8" of differential between hot and cold temperatures into an electrical signal

The LWTS attaches to the cold water line of your washer's water inlet valve. It monitors the temperature of the incoming cold water, and will activate an alert lamp on your washer if the temperature drops below 33°F. This alert tells you to turn up the temperature setting.

A two KTuner water-temperature controller for monitoring when the water leaving your heat exchanger is between 65°F and 100°F. Solid state electronic temp sensor is pre-wired for connections to both inlet and outlet tempertature probes, this controller with LCD displays in either Fahrenheit or Celsius.

The York YK-40 Water Temperature Sensor automatically adjusts the time and temperature of your electric water heater to help reduce energy costs while protecting against scalding hot water and burning the elderly and infirm. Not only does it offer a safer life, but also a more convenient life with:

Easy-to-install, easy-to-use water temperature monitor can be installed in minutes. Just snap sensor into the outlet port for a specific faucet and attach the included wire to a grounded electrical outlet inside your home.