WHITE-RODGERS 5057 PLUG-IN MERCURY FLAME SENSOR 48"

PLUG-IN MERCURY FLAME SENSOR 48"

The WHITE-RODGERS 5057 PLUG-IN MERCURY FLAME SENSOR is an affordable way to get a little extra peace of mind on your HVAC system. The sensor can be used with installation in just a few minutes, and it will alert you if your pilot light is not functioning as it should. Its mercury switch detects even slight differences in temperature, helping you make sure that your pilot light will stay lit. The tough polycarbonate housing stands up

20 Amp Straight Blade Plug-In Mercury Flame Sensor 48" *** WHITE-RODGERS brand products help make controlling your home environment easier. Use with a 24V System for electric and heat-pump systems that require a lower flame setting than a 100CPSL Mercury Flame Sensor. With a 20 Amp plug-in version, it offers the perfect solution for new construction applications where the wiring has not been completed. Features tip over protection and emergency reset. Flame sensor can also be hard wired

Introducing the PLUGIN MERCURY Heating System; a revolutionary lighting technology for gas ranges, cooktops, ovens and fireplace inserts. The PLUGIN MERCURY Flame Sensor reads the mercury in a gas flame to assure optimum ignition regardless of the type or condition of the burner. This truly innovative device also eliminates nuisance lights caused by induction systems. Its wireless design allows it to be installed in minutes and is compatible with most gas applications.

The White-Rodgers Plug-in Mercury Flame Sensor is easy to install and connects to your mobile device with the Kwiksy app, allowing you to monitor and control your thermostat from anywhere. Connectivity extends even outside your home, so you can check the status of your system at any time, all while keeping energy usage in check.

The White-Rodgers 5057 plug-in mercury flame sensor features a unique, non-mercury design that is quick and easy to install. With no wires to cut or work around, this flame sensor can be used with any firewall capable thermostat. A simple 1/8" hex key is all it takes to remove and adjust the sensor. (The sensor will not work with Wi-Fi and RTU thermostats) .

This MERCURY FLAME SENSOR is designed to be installed into any gas-fired, direct-venting appliance where the MERCURY FLAME SENSOR will measure the flame height and activate based on contact with flame. This device meets the requirements of NFPA Code 104 when installed in accordance with National Fuel Gas Code ANSI Z223.1/MSS-SP14 (2013 edition). This site-specific application should be installed in place of the original flame sensor

The plug-in type flame sensors are available in a 48" square and 24" x 60" rectangle shape. The sensor bar is made of flameproof, high temperature plastic composite material. With a self-cleaning heating coil, the safety modules are capable of handling sensor overheat conditions, will not accumulate mineral deposits, and can be cleaned with soap and water