HONEYWELL 10613 24V DIRECT-COUPLED NON-SPRING RETURN DAMPER ACTUA

24V DIRECT-COUPLED NON-SPRING RETURN DAMPER ACTUAT

This 24V DIRECT-COUPLED NON-SPRING RETURN DAMPER ACTUATOR is a potentiometer type pneumatic actuator that can be used for both proportional and on/off control.

HONEYWELL 10613 24V DIRECT-COUPLED NON-SPRING RETURN DAMPER ACTUAT

Drastically reduce unwanted or excess noise in your home while enhancing the quiet ambience you're trying to achieve with the Honeywell 10613 24V Direct-Coupled Non-Spring Return Damper Actuator . This damper actuator offers smooth, constant air flow to any standard 24-volt baseboard heater or fan motor, and is suitable for use on any wood-burning fireplace or furnace. Its dual gear washers are durable in all weather conditions, and its 1/4 HP along with 1325 rpm motor ensure quiet operation and extended performance.

The Honeywell 10613 24V Direct-Coupled Non-Spring Return Damper Actuator is designed to provide positioning for Fire Door assemblies. This actuator features a selectable stop and access to two float levels. The actuator has a NEMA 4X Nickel Roller 5/8 in shafts, Yoke Bushing, and Wedge Face Adapter for mounting.

Directly-coupled, non-spring return damper actuator has just a single flex circuit. Cabled damper is activated by a solenoid operator using either thermostat control or electronic contact regulator control. Ball bearing guide for maximum reliability has built-in limit switch for a non-binding wear surface. Same size as standard size 10611B, but with an 2? bore. Requires mounting bracket 14063 (sold separately) and T10 wrench tool (available below) to complete installation

The Honeywell 10613 DIRECT0COUPLED NON-SPRING RETURN DAMPER ACTUATOR is as least as quiet as a spring return damper actuator, but it accommodates misaligned ductwork, variable air flow and reduced maintenance.

The Honeywell 24V Direct-coupled non-spring return actuator is a floating body, direct coupled type designed for usage in Actuation systems requiring precise control action and a positive end of travel. Actuator can be actuated directly from a solenoid mounted on the valve body or by mounting the actuator and solenoid on a common baseplate.