CONTROLLER *** RESTRICTED ITEM PLEASE CALL ***
HONEYWELL CONTROLLER, Ecm35323-X1573-Rm7895-Ap. Fits On/Off Furnaces For Conditioning And Heating Systems. This Honeywell Rm7895, Ap Primary Control comes with a 50' wire pigtail and is for use on YANKEE (Y), ZENITH (Z) AMANA (A), CHILLERTONE (T), LEVELONE (L1), BRADY-(Brco) and CAMPBELL-HARRIS(CH). The Honeywell 35323 RPi-1 C74
THE "PUSH TO TURN" CONTROLLER IS A REPLACEMENT CONTROLLER FOR ALL RESIDENTIAL AND COMMERCIAL WALL MOUNTED IGNITION CHIMNEYS WITH A 4" DIA. STACK. THE PART NUMBER FOR THIS CONTROLLER INCLUDES A C, D OR E AFTER IT DEPENDING ON THE APPROVED APPLICATION OF THE CONTROLLER.
The Honeywell 35323 Primary Control with Prepurge control has a hinged bumper that makes it easy to install without the need for screws. It works with 1 or 2 wire inputs and is compatible with such models as 6150ESL1, 6160ESL1, 6160TTL2, 620U, 620UL3, 6400EC23BA100-264VAC, 6400EC23BA100-120VAC and 6400EC23BN100-120VAC. Comes in white color.
Note: Unless otherwise specified, all items tested do not conform to UL, CUL. Using a Honeywell Primary Control with Prepurge unit on a gas or oil fired appliance can cause sensitive electronics in the control to fail because of excessive heat generated by the burner. This item is for use with portable gas-fired and oil-fired LP appliances rated at 40,000 Btu/hr or less. Primary Controls are designed for switching a power supply on and off under normal operating conditions, i.e., where energy demand is continuous. They are not intended for use on air conditioners or refrigerators, since refrigerator
The 35323 Temperature Controller regulates both on/off and proportional control for devices with model numbers that begin with an "E". It has a built-in, easy to use interface, which operates on either 115 VAC or 230 VAC power. This controller is designed to protect all electrically powered equipment where manual temperature control is required and precise temperature sensing and recovery are desired.
The 35323 is a Honeywell digital, single-gang, primary pressure control designed to be the ultimate pressure controller for gas furnaces. This switch will use the same multistage burner to fire your furnace that it uses in its own pilot-on test. It features a flame failure relay with an adjustable guard time and automatic shutdown, room temperature compensation that monitors room temperature to determine operating pressure, and a ramp feature that helps you clean up cycling so it keeps your furnace from firing and cycling on and off too often. Locking front buttons prevent accidental changing of settings.
Dial-A-Temp controls the amount of Heat produced by your furnace. By turning the control to a desired temperature, you direct more or less heat to the blower motor and to the air circulated throughout your home. The result is steady, comfortable heating with no energy waste.