Honeywell 2286 Damper Motor, Two Position, SPST, 120 Vac, 20 lb-in torque

HONEYWELL M436A1116 120V 2 POS. DAMPER ACT.

The Honeywell 2286 is a 120VAC two position damper actuator with spst, 120VAC solenoid output, an output force range from 20 to 150 lb-in, and an operating frequency range of 1.5 to 5.6 per sec. The Honeywell 2286 Series is in line with safety standards such as UL, CSA and CE CUSI compliant and features a quick disconnect for easy installation.

The Honeywell 2286 two-position damper motor has a 20 lb-in. (88.9 Nm) torque and a 120 VAC, 50/60 Hz operating voltage. This device is measured at a single phase for variable speed function and is used in heating applications with its rating of (110 watts).The Two Position Damper Actuator from Honeywell, part number 2286, is rated for ease of use with its (1-1/2") adjustment instruction permanent

The Honeywell Series 2286 damper actuator is a two-position, normally open or normally closed valve operator. The damper actuator is used in applications requiring an adjustable torque motor that has limited space requirements. This unit is mounted on a standard D shaft and comes with a convenient 5-pin connector. An inverter timer may be added to the motor to allow the damper to operate in any position. ``

This HONEYWELL 2286 Motor is a conventional two-position (ON-OFF) motor for use in single-speed, two-stage damper applications. This ball bearing motor has a NEMA mounting flange for either horizontal or vertical application. The holding torque for each setting is 20 lb-in at approximately 184 oz-in rms.

Mounting is accomplished by two mounting screws so that the damper motor can be mounted in any position desired. The rotor comes wound with 22 gauge wire for low temperature applications. This damper actuating motor operates on 120 volt, single phase, 20 lb-in torque to control and open or close the ball and socket dampers. It switches up to 4 horsepower.

The Honeywell 2286 is a two-position damper motor offering a basic switch and a step control that opens from closed to either the 3/4 or full position. It has four mounting holes in an L-shaped configuration on the side of the case. Based on load requirements, this design is capable of providing up to 20 lb-in of holding torque.

With a load current rating of 17 amps and a motor torque rated at 20 lb, this damper motor can effectively control any 2 position damper system.