Honeywell 6381 150 lb-in Modutrol IV Motor, 120V, 90 degree stroke, 30 sec, 4-20mA Input

120V VALVE/DAMPER ACTUATOR 150LB-IN

A compact two-way valve/damper actuator that encloses a heavy duty, re-usable two-way valve within an NEMA 4X rated housing. The unit is intended for applications where limited space is available and where multiple, variable speed control capability is needed whether they be applied via pushbutton controls or externally from plant or process automated controller systems.

The Honeywell Series 6381 Modutrol IV Motor is designed for Damper/Valve Control applications. This motor features a high-stiffness rotor that provides a 90 degree offset winding design. The damper linkage rotates a 120V lens block to control the damper position. The motor is offered in 1/8HP, 1/4HP and 3/4HP models and has a service factor of 1:1. It is supplied with an integral gear box with a 90 degree, optical sensing index potentiometer (type #9235) and drives a 150 lb-in spring linkage table at

Six position motorized valve/damper actuator with 0.180? stroke and 90? motor lead. Electrical rated voltage: 120VAC, 60Hz; Lead-wire configuration: 4-20mA. Maximum valve travel: 0.180?; Relief port size: 1/2? NPT; Damper position: 90? open, 45? closed; Output shaft diameter: 1/2?; Input power required: 7W; Mounting style: Panel mount

The Modutrol IV is a 6 HP, 90 degree, 150 lb-in electromechanical actuator. It contains a mechanical control valve for use when control of precise flow rate is not necessary or desired. It is designed for pneumatic control of one or two-way, normally closed dampers and valves in commercial HVAC (heating, ventilation and air conditioning) systems for applications such as variable air volume systems, low pressure drop systems and variable air flow systems. The Modutrol IV has four quarter-turn taps with the tap values being factory set to allow ease of installation and to provide operation

Modutrol IV is the smallest, quietest and easiest to install high performance air pressure actuation system available. This direct-acting two-way valve/damper actuator provides aggressive air power in a compact package. It is designed for use with the Honeywell control systems listed below and operates with 30 seconds/4–20mA input signals.

The Honeywell 6381 150 lb-in Modutrol IV Motor, 120V, 90 degree stroke, 30 sec, 4-20mA Input is an adjustable motor control that can operate a variety of valves. It is a very versatile controller with quick response time and an impressive load rating of 150 lbs-in.

The Honeywell 6381 150 lbs. in. Modutrol IV Motor from AutomationDirect.com has a maximum linear travel of 30 inches and is meant for electronic positioners in HVAC applications and requires a 4-20mA current signal for control. This motor is designed to handle both internal pressure and vacuum conditions, and can be installed vertically or horizontally in flat panel duct work.