York S1-024-19082-031 24V Heat Sequencer Relay

24V Heat Sequencer Relay

The 24V Heat Sequencer Relay is a solid-state, single-pole, single-throw changeover device designed to switch heating circuits under program control. The relay permits sequencing of two shaded pole or shaded coil heaters through an electric heat strip cord or an indoor placard heater under the supervision of a programmable logic controller, timer, or rheostat.

The York S1-024-19082-031 24V Heat Sequencer Relay is a solid-state heat device designed to supply hot water to a register after a set temperature has been reached. This relay is activated by a temperature activation transformer, constant temperature controller, or baseboard heater low/high limit control. The 24V Heat Sequencer Relay only requires the mounting of the bi-metal thermostat wire and neutral wires. The low voltage wiring can be hidden from view making installation easy and lasting longer.

This is a 24V Heat Sequencer Relay. This relay will turn your hot water heater off for 1 minute to prevent scalding, even if it is left on by mistake.  The heat sequencer has an adjustable timer that turns the water heater off for up to 9 minutes, with 5-minute intervals between each timed shut off.

The York S1-024-19082-031 24V Heat Sequencer Relay is a device that triggers an electrical circuit to ensure that heat or air conditioning cycles correctly. When current passes through the coil, it interacts with the bimetallic strip to change the shape of the strip. If you're experiencing slight abnormalities with your heat or air conditioning, this may be the equipment you need to fix the problem.

The York 24V Heat Sequencer Relay is an electrical control device that is designed to hold one or more 24V heaters on and off as programmed. With the ability to control up to 92 zones, you can install as many as eight of these sequencers within a single furnace for ultimate convenience and efficiency.

When you add this Heat Sequencer Relay to your York YR120 Control Board, you can use a programmable thermostat with the unit. The S1-024-19082-031 from York Control Inc provides 24V power from a low voltage control system to the unit's high voltage systems for building heating and cooling, including several stages of operation.

The York Heat Sequencer Relay S1 is designed to operate two 120 volt, two pole, two position heating circuits. The contactor coil is rated for 24 volts AC at 100 amps continuous, with a turn-on capacity of 160 amps. The contacts are rated for 11 amps at 250 volts DC maximum. This heat sequencer relay fits in most standard control panels and the 5/8 inch DIN rail makes installation easy. It also features an optional Cable-Labor Intensifier for models ZSSE2X50E and ZSSE3X50E.