York S1-024-19082-738 Heat Sequencer Time Delay Rly Heat Sequencer Time Delay R

Heat Sequencer Time Delay Rly

York S1-024-19082-738 Heat Sequencer Time Delay Rly. Fan; ceiling; bathroom; five (5) wire; trip time 1 to 99 sec.; 60 Hz; AC only; 240 VAC; NEMA 1 enclosure.

York S1-024-19082-738 Heat Sequencer Time Delay Rly 875 kg - Time Delay Relay.

The York S1-024-19082-738 Heat Sequencer Time Delay Relay is a replacement for use with your York furnace, and will help control the heating system. It helps save energy by turning the equipment off after a period of time, or when the temperature is reached. This delay allows the area to warm up, and then cool so it doesn't overheat the room. This Heat Sequencer Time Delay Relay features a Replacement heat sequencer time delay relay for use with your York furnace, and a heatsensitive bi-metal coil that acts as a temperature sensor.

You can find an HVAC timer that meets your specific needs here at PLC.com. The York Heat Sequencer Time Delay Relay - YS1-024-19082-738 has a low profile design and a one inch mounting. YS1 Relays feature 16 connections available for wiring. This 0008 is for controls up to 64 amps, is stackable, and comes with three mounting screws. For precise control of your HVAC unit, this 0008 is an ideal selection for you!

The York Heat Sequencer Time Delay Relay provides time delay for selecting auxiliary heat. The time delay relay can be used to turn on and off other equipment such as humidification supplies after an initial warm-up period.

A heat sequencer time delay relay is used to control when heating circuits are energized or deenergized in order to maintain temperatures within a range over a period of time.

The York Heat Sequential time delay relay is designed to control single phase electric heaters or accessories with 3 terminals. It is equipped with a mercury tilt switch to trigger the relay when the mercury tilts in either direction. The circuit is similar in operation for both up and down motion of the mercury.  The time delay function will delay off for 2 seconds after the mercury trips the up-down sensor then cycle on for 8 seconds when the mercury trip occurs in that direction then shut off for 50 seconds when mercury trips in opposite direction