York S1-024-23285-700 "-0.53""WC SPST PRESSURE SWITCH" "-0.53""WC SPST PRESSURE

"-0.53""WC SPST PRESSURE SWITCH"

This product is an epoxy-encapsulated pressure switch that switches at 0.53""WC. This product is most commonly used behind pressure-compensating relief valves to activate a warning light or alarm system when the prespecified set point is reached.

"SPST Pressure Switch"

This pressure switch is used for water filters and other applications requiring a water shut-off function. It has a large ON OFF/reset lever for manual actuation from 0 to 175 psi. This unit is designed and manufactured to IEC61508:2008 (ATEX) and UL standards to meet both the performance requirements and the safety requirements for intrinsically safe equipment.

The YORK S1 Series pressure switches are built for electrical applications in both commercial and industrial applications.

The S1-024-32101 is a low pressure switch. It has two ports. When the flow crosses the lower port, the pressure rises and the contacts open. When the pressure drops below the upper set point, the contacts close. The switch resets itself when the pressure returns to normal.

A pressure switch that is designed and built for use in water filtration systems. It has an adjustable range of 0 to 10 psi with a 1/4 inch quick disconnect (QD) port fitting. This switch is a normally open switch that closes when the set point is reached. The contacts are both rated at 3A 125VAC continuously and 5A 125VAC for 1 minute.

For use with drain, waste, vent and temperature applications. Purge, "ON-OFF" button changes the state of the switch from "ON" to "OFF" upon releasing. Removable steel lever allows for easy installation and maintenance. Mounting bracket is removable from the switch body by unscrewing thumbscrews. Does not protect against overpressure-if over pressure occurs while drain line is open, drain line will likely rupture causing personal injury or property damage.